Skip to content Skip to navigation Skip to footer
POLARIS OFF-ROAD VEHICLES
HELP CENTER
09/09/2024

2024+ Polaris XPEDITION Floor Rails Kit Installation

This video goes over the installation of the Lock & Ride MAX Rail Kit for the Polaris XPEDITION XP and XP 5 bed (part number 2889622), Polaris XPEDITION ADV and ADV 5 bed (part number 2889621) and Polaris XPEDITION XP 5 and ADV 5 rear floor (part number 2889623). For more information, view the instructions for each part of this kit by searching the Polaris Accessory Installation Instruction Site.

Required Tools and Supplies

  • T40 TORX®
  • 4mm Allen Socket
  • Ratchet
  • Torque Wrench
  • Eye Protection
  • Nitrile Gloves
  • Shop Rags

For information on tools, read the Tools and Fasteners Guide. Always wear safety glasses and nitrile gloves when installing accessories on your Polaris XPEDITION.

To install the Floor Rails Kit on your Polaris XPEDITION, follow these steps. 

1. Park the vehicle on a flat, level surface, ensure it is in PARK and remove the key.

2. Tilt the rear seats up.

3. Remove the four screws from the rear seat floor with a T40 TORX®.

4. Before installing the rails, make sure to install the end caps.

5. Install the rails and two screws in each of the floor channels. Torque to 106 in-lbs (12 Nm) with a 4mm Allen socket and lower rear seats.

For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

TORX® is a registered trademark of Acument Intellectual Properties, LLC
YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2023 Polaris Industries Inc.