Required Tools and Supplies
19mm Socket
Breaker Bar
Torque Wrench
Brake Pad Measurement Tool
Tire Pressure Gauge
Tread Depth Gauge
Flashlight
Eye Protection
Nitrile Gloves
Shop Rags
To inspect the wheel and brake system and perform a tire rotation on your RZR Pro R Boost, follow these steps:
1. Park the vehicle on a flat, level surface, ensure it is in PARK and remove the key. Note: RZR Pro R Boost Ultimate 2-Passenger model shown.
2. Take a close look at each tire.
Inspect for damage that may compromise the integrity of the tire.
Verify there is sufficient tread depth. Tires should be replaced once they reach one-eighth inch or 3 millimeters of tread depth.
Inspect the tire pressure and verify it is set to specification. Reference the Owner's Manual or tire pressure label on your vehicle for the correct specs.
Take a close look at how the tires are wearing. If there is irregular wear, it may be time for a rotation.
3. Remove the wheels from the vehicle.
Begin by loosening the lug nuts with a 19mm socket with breaker bar while the vehicle is on the ground, but do not remove the lug nuts at this time.
Safely elevate the vehicle. Reference your Owner's Manual for proper lifting techniques.
Once safely elevated, remove the lug nuts, and set aside.
Remove the wheels and set aside.
4. Inspect the fluid level and condition in the master cylinder, located in the driver’s side front wheel well. Ensure the level is between the upper (MAX) and lower (MIN) level lines. If it is low, clean around the cap and add brake fluid as necessary from a new and unopened bottle. DOT 4 brake fluid is part number 2872189. Apply the brake forcefully for a few seconds and check for fluid leakage around the fittings. Note: Do not allow brake fluid to contact painted surfaces or paint damage may occur.
Check the brake system for fluid leaks.
Check the brake pedal for excessive travel or a spongy feel.
Check the friction pads for wear, damage and looseness.
Check the brake discs for signs of cracks, excessive corrosion, warping or other damage. Clean any grease using an approved brake cleaner or alcohol.
5. Take a look at the brake pads. Note: Always allow the brakes to cool completely before inspecting to prevent the risk of burns.
Check the brake pad thickness using a suitable tool. Be sure to inspect the brake disc spline and pad wear surface for excessive wear. Replace any pads that are worn beyond their minimum thickness of 0.03 in (0.762 mm). Note: If inspection reveals any concerns, Do NOT attempt to drive the vehicle. See your authorized Polaris Service Center.
6. Once the brake system inspection has been completed, the tires can be rotated and reinstalled. A tire rotation is recommended every 500-miles (805 km). Perform the tire rotation on the vehicle as shown.
7. Rotate the wheels as needed based on wheel configuration.
Place the wheel on the hub with the valve stem toward the outside and if applicable, point the rotation arrows pointing toward forward rotation.
Attach the lug nuts and finger-tighten.
Once lowered, torque the lug nuts to specification in a crisscross pattern. Torque the lug nut (aluminum wheels) to 148 ft-lbs (200 Nm). Torque the hub retaining nut to 88.5 ft-lbs (120 Nm).
For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
More maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
YouTube® is a registered trademark of Google LLC
Unless noted, trademarks are the property of Polaris Industries Inc.
© 2026 Polaris Industries Inc.