2027 RZR Pro R Boost Transmission (Main Gearcase) Fluid Change

Required Tools and Supplies

• 8mm Ball End Allen Socket

• Extension

• Ratchet

• Torque Wrench

• Fluid Filler

• Drain Pan

• AGL Extreme Fluid

• Eye Protection

• Nitrile Gloves

• Shop Rags
   

To change the transmission or main gearcase fluid on your RZR Pro R Boost, follow these steps:

1. Park the vehicle on a flat, level surface, ensure it is in PARK and remove the key. Note: RZR Pro R Boost Ultimate 2-Passenger model shown.

2. Place a drain pan under the drain plug. Tip: Placing a rag in the bottom of the drain pan will help prevent the splashing of fluid.

3. Clean the area around the fill plug.

4. Remove the fill plug using an 8mm ball end Allen socket and set it aside.

5. Clean the area around the drain plug.

6. Once cleaned, remove the drain plug using an 8mm Allen socket and allow the fluid to drain completely.

7. Before reinstalling, clean any dirt or debris from the fill and drain plugs.

8. Inspect both plugs and ensure the sealing surfaces are free of any burrs, nicks or scratches and replace, if necessary.

9. Inspect the O-rings on both plugs and replace, if necessary.

10. Reinstall the drain plug and torque to 10-14 ft-lbs (14-19 Nm).

11. Add the AGL transmission fluid (part number 2878068 for one quart, and part number 2878069 for one gallon) through the fill plug hole until the fluid is even with the bottom of the fill plug hole. The fluid capacity is 2 qt (1892 mL).

12. Reinstall the fill plug and torque to 10-14 ft-lbs (14-19 Nm).

13. Once complete, clean any residual fluid from around the drain and fill plugs and inspect for leaks.

14. Dispose of the used fluid properly at your local recycling center.