Required Tools and Supplies
T40 TORX® Socket
10mm Socket
Extension
Ratchet
Torque Wrench
Dielectric Grease or Petroleum Jelly
Eye Protection
Nitrile Gloves
Shop Rags
To remove and install the battery on your RZR Pro R Boost, follow these steps:
1. Park the vehicle on a flat, level surface, ensure the vehicle is in PARK and remove the key. Note: RZR Pro R Boost Ultimate model shown.
2. Begin by disconnecting the heated and ventilated seat connector.
3. Remove the driver seat by pulling up on the seat latch lever located under the front edge of the seat. Then tilt the seat forward and upward to remove from the vehicle. Note: Disconnect the heated/ventilated seat connector prior to removing the seat.
4. On the right-most battery, remove the battery terminal post to disconnect the negative (-) black battery cable from the battery.
5. Repeat on the left-most battery using a 10mm socket. Tip: Reinstalling the fasteners into the battery posts will help prevent misplacement.
6. On the right-most battery, remove the battery terminal post to the positive (+) red battery cable from the battery.
7. Repeat on the left-most battery.
8. Using a T40 TORX® socket, remove the four screws securing the battery hold-down strap and set the strap aside.
9. Pull the battery toward the driver’s side of the vehicle and tilt it up to remove. Continue by pushing the seat lever and slide the seat forward. Pull the battery toward the driver’s side of the vehicle and tilt up to remove.
10. If reinstalling the battery, ensure it is fully charged and free of any debris to prevent damage. Follow the instructions in the Battery Charging section of your Owner's Manual before installing the battery. If necessary, a new battery is part number 4014609.
11. Clean any dirt or debris from the battery box.
12. Place the battery into the battery holder and slide into place.
13. Once complete, slide the seat all the way back.
14. Install the battery hold-down strap and torque to 53 in-lbs (6 Nm).
15. On the left-most battery, connect the positive cable. Repeat on the right-most battery.
16. On the left-most battery, connect the negative cable. Repeat on the right-most battery. Torque both to 44 in-lbs (5 Nm).
17. Coat both terminals with dielectric grease or petroleum jelly.
18. Reinstall the positive cable protector boot.
19. Before proceeding, verify the cables are secure and properly routed.
20. Reinstall the seat by sliding the seat tabs at the front edge onto the seat retainer tubes. Then press down firmly at the rear of the seat to engage the rear latches. Ensure the seats are latched securely.
21. Once complete, reconnect the heated and ventilated seat connector.
22. Turn the key ON to verify the battery has been connected properly. Note: When the battery is disconnected, the vehicle’s clock may need to be reset.
For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
More maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
YouTube® is a registered trademark of Google LLC
TORX® is a registered trademark of Acument Intellectual Properties, LLC
Unless noted, trademarks are the property of Polaris Industries Inc.
© 2026 Polaris Industries Inc.