Skip to content Skip to navigation Skip to footer
POLARIS OFF-ROAD VEHICLES
HELP CENTER
10/13/2026

2027 Sportsman 500 Oil and Filter Change

Required Tools and Supplies

  • 6mm Allen Socket

  • Ratchet

  • Torque Wrench

  • Oil Filter Wrench

  • Oil Pan

  • Funnel 

  • PS-4 Engine Oil

  • Oil Filter

  • Eye Protection

  • Nitrile Gloves

  • Shop Rags

To change the engine oil and filter on your Sportsman 500, follow these steps:

For optimal performance, always use Polaris recommended fluids as described in your Owner’s Manual.

1. Park the vehicle on a flat, level surface, ensure the vehicle is in PARK and lock the temporary brake.

2. Place a drain pan under the engine drain plug. Tip: Placing a rag in the bottom of the drain pan will help prevent the splashing of oil.

3. Clean the area around the drain plug.

4. Remove the drain plug and washer with a 6mm Allen socket and allow the oil to drain completely. Caution: Hot oil can cause burns to skin. Do not allow hot oil to contact your skin.

5. Continue by cleaning any dirt or debris from the drain plug and install a new sealing washer. Note: The sealing surfaces on the drain plug must be clean and free of burrs, nicks, and scratches.

6. Install the drain plug and torque to 12 ft-lbs (16 Nm).

7. After this, move the drain pan below the oil filter.

8. Wipe the area around the oil filter and place a rag under the oil filter to catch any spillage.

9. Use an oil filter wrench and turn the filter counterclockwise to remove.

10. Continue by using a clean dry cloth to clean the filter sealing surface on the engine crankcase.

11. Lubricate the O-ring on the new filter (part number 2520799) with a film of fresh engine oil and ensure the O-ring is in good condition.

12. Install the new filter and rotate it clockwise by hand until the filter gasket contacts the sealing surface. Then turn it an additional 3/4 turn.

13. Remove the engine access panel on the right side of the vehicle.

14. Clean the area around the oil dipstick and remove.

15. Use a funnel to slowly add PS-4 5W-50 4-Cycle Oil to bring the oil level within the safe range on the dipstick. The capacity is 2 quarts (1.9 L). Do NOT overfill. The engine oil is part number 2876244 for 1 quart, and part number 2876245 for 1 gallon. 

16. Start the engine and allow it to idle for 1 to 2 minutes.

17. Stop the engine and check for any leaks.

18. Remove the dipstick and wipe with a clean shop towel. Reinstall the dipstick fully and remove again to inspect the oil level. The oil level should be between the full and add lines on the dipstick. Add oil as needed. Do NOT overfill.

19. Reinstall the dipstick and wipe away any residual oil.

20. Dispose of the used oil and filter properly at your local recycling center.

For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2026 Polaris Industries Inc.