Skip to content Skip to navigation Skip to footer
POLARIS OFF-ROAD VEHICLES
HELP CENTER
10/14/2026

2027 Sportsman 500 Spark Plug Service

Required Tools and Supplies

  • 5/8-in Socket

  • Swivel

  • Ratchet

  • Flathead Screwdriver

  • Multifunction Pliers

  • Torque Wrench

  • Eye Protection

  • Nitrile Gloves

  • Shop Rags

To change the spark plug on your Sportsman 500, follow these steps:

1. Park the vehicle on a flat, level surface in a well-ventilated area, ensure the vehicle is in PARK and set the parking brake.

2. Before proceeding, allow the engine to cool.

3. Remove the driver seat.

4. Remove the left-side panel with multi-function pliers.

5. Loosen the boot worm clamp on the outer clutch cover and remove the clutch outlet duct using a flathead screwdriver.

6. Clean the spark plug area with a clean shop rag so no dirt and/or debris falls into the engine.

7. Remove the spark plug cap by rotating the cap 1/4 turn and pull it off the spark plug. Tip: Clean out the plug wells with compressed air to remove any loose dirt or debris.

8. Carefully remove the spark plug by rotating it counterclockwise using a 5/8-in socket with swivel.

9. Inspect the electrodes for wear and carbon buildup. Look for a sharp outer edge with no rounding or erosion of the electrodes.

10. The normal insulator tip is gray, tan or light brown. There will be a few combustion deposits. The electrodes are not burned or eroded. This indicates the proper type and heat range for the engine and the service.

11. The tip should not be white. A white insulator tip indicates overheating, caused by use of an improper spark plug or incorrect throttle body adjustments.

12. A wet fouled insulator tip is black. A damp oil film covers the firing end. There may be a carbon layer over the entire nose. The general cause is excessive oil consumption, use of non-recommended oil or poor fuel quality.

13. Clean the spark plug.

14. Inspect and adjust the spark plug gap, if needed. The spark plug gap should measure 0.033 in (0.084 cm).

15. If necessary, replace with the recommended spark plug. Refer to your Owner's Manual for recommended spark plugs.

16. Install the spark plug and torque to 15 ft-lbs (20 Nm). Tip: Apply a small amount of dielectric grease or petroleum jelly to the spark plug cap.

17. Reinstall the clutch outlet duct to the boot and torque the clamp to 20 in-lbs (2 Nm).

18. After this, reinstall the left side panel.

19. Reinstall the seat and ensure it is seated and secure.

20. Start the engine to ensure proper operation.

For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2026 Polaris Industries Inc.