Skip to content Skip to navigation Skip to footer
POLARIS OFF-ROAD VEHICLES
HELP CENTER
10/30/2024

2016-2024 Sportsman High Lifter Pre-Ride Inspection



Before you ride your Polaris Sportsman 850 High Lifter Edition or Sportsman XP 1000 High Lifter Edition, perform the pre-ride inspection as described in the Owner’s Manual. Read, understand and follow all of the instructions, warnings and safety precautions in the Owner's Manual and on all product labels. Failure to do so could result in serious injury or death. 

1. Visually inspect the vehicle, looking for debris, leaks and worn components that may impair the vehicle’s operation. Remove any debris and perform any repairs needed before riding.

  • Pay particular attention to the radiator area for the accumulation of debris, which can cause the engine to overheat, and clean any debris that is found.

2. Check the condition of the tires, looking for any sign of punctures or damage, and inspect the tread depth.

3. Also check the tire pressures and verify they are set to specification. The tire pressure should be 7 psi (48 kPa) on all tires.

4. Inspect the front and rear suspension for leaks, debris and damage.

5.  Inspect the brake pads and rotors, looking for corrosion, nicks and burrs.

6. Lift up on the two front latches and remove the front cover. Then inspect the engine and PVT intake snorkels for blockage or debris, and clean as needed. Reinstall the cover, ensuring the front retaining tabs are engaged, and lock the two front latches.

7. Lift up on the rear of the seat and pull back to remove. Inspect the air filter box for any damage or leaks. Reinstall the seat by aligning the front retaining tabs and pushing down in the rear.

8. Ensure the vehicle is on a level surface to inspect the fluid levels.

9. Begin by inspecting the front brake reservoir on the left handlebar for proper fluid level. A flashlight can be used to illuminate the reservoir in dark areas.

10. Inspect the coolant level in the overflow bottle in the right front wheel well. Add coolant as needed. 

11. Inspect the engine oil level on the left side of the vehicle. Ensure the oil level is checked on a cold engine. A hot engine will appear overfilled.

  • Clean the area around the oil dipstick. 
  • Turn the oil dipstick counterclockwise to remove and wipe with a clean shop towel.
  • Reinstall the oil dipstick fully and remove it again to inspect the oil level. 
  • Add the recommended oil as needed. Do not overfill.

12. Turn the key ON. Inspect the fuel level and ensure there is enough fuel for your trip.

13. Verify proper operation of the headlights, taillight and brake lights.

14. Check the steering for smooth operation from full left to full right.

15. Verify proper brake and throttle pedal movement, taking note of any binding or sticking.

16. Ensure proper operation of the footbrake.

17. Set the parking brake and ensure the vehicle does not roll.

18. Start the engine and verify the low oil pressure light is not illuminated. 

19. Stop the engine with the stop and run switch, Verify it does not restart.

20. Lastly, always practice safe riding by wearing the required safety gear listed in your Owner’s Manual.

For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Industries Inc.