Required Tools and Supplies
17mm Socket
T20 TORX® Socket
Breaker Bar
Torque Wrench
Brake Pad Measurement Tool
DOT 4 Brake Fluid
Tread Depth Gauge
Tire Pressure Gauge
Eye Protection
Nitrile Gloves
Shop Rags
To inspect the wheel and brake system and perform a tire rotation on your Sportsman 500, follow these steps:
1. Park the vehicle on a flat, level surface, ensure the vehicle is in PARK and set the parking brake.
2. Take a close look at each tire.
Verify there is sufficient tread depth. Tires should be replaced once they reach one-eighth inch or 3 millimeters of tread depth.
Inspect for damage that may compromise the integrity of the tire.
Inspect the tire pressure and verify it is set to specification. Reference the Owner’s Manual or tire pressure label on your vehicle for the correct specs.
Take a close look at how the tires are wearing. If there is irregular wear, it may be time for a rotation.
3. Inspect the fluid level and condition in the front master cylinder, located on the left handlebar.
4. If fluid is needed, clean the area with a clean cloth.
5. Remove the two cover fasteners using a T20 TORX® socket.
6. Lift the cover and diaphragm off and set aside. Note: Do not allow brake fluid to contact painted surfaces or paint damage may occur.
7. Add fluid as needed. Do not overfill.
8. Reinstall the diaphragm, cover and fasteners and fasten until fully seated.
9. Inspect the brake fluid level for the auxiliary brake system. The reservoir is located under the driver seat. Maintain the fluid level between the maximum and minimum marks. Use DOT 4 brake fluid only and add as needed.
10. Continue by moving to the wheels and loosening the lug nuts slightly with a 17mm socket and breaker bar.
Safely elevate the side of the vehicle by placing a suitable stand under the footrest frame. Warning: Make sure the vehicle is properly lifted and supported.
Remove the lug nuts and wheel.
Follow the front brake lines from the front reservoir to the front junction block in the center of the chassis frame.
Continue inspecting the brake lines to both front calipers, looking for any leaks, kinks or damage.
Ensure the brake line retainers are properly secured.
Inspect the connections at the front brake calipers for leaks or damage.
11. Take a look at the brake pads. Note: Always allow the brakes to cool completely before inspecting to prevent the risk of burns.
Check the brake pad thickness using a suitable tool. Be sure to check the thickness on the inside pads as well and replace any pads that are worn beyond their minimum thickness. The minimum thickness is 0.030 in (0.762 mm).
12. Check the security and surface condition of the disc.
Clean any grease using a recommended brake cleaner or alcohol. If inspection reveals any concerns, see your dealer for service before operating.
13. Follow the brake lines back to the rear of the vehicle, looking for leaks, kinks and damage. Ensure the brake line retainers are properly secured.
14. The tires can be rotated, if applicable, and reinstalled. Note: Due to different configurations, some wheels may not be able to be rotated. Always pay attention to all markings and directional indicators on the tires.
Install the wheels on the vehicle and hand tighten the lug nuts.
Safely lower the vehicle to the ground and torque the lug nuts to specification. For steel lug nuts, torque to 27 ft-lbs (37 Nm). For aluminum lug nuts, torque to 30 ft-lbs (40 Nm) + 1/4 turn.
For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
YouTube® is a registered trademark of Google LLC
Unless noted, trademarks are the property of Polaris Industries Inc.
© 2026 Polaris Industries Inc.