Required Tools and Supplies
- T40 TORX® Socket
- 10mm Socket
- Extension
- Ratchet
- Torque Wrench
- Dielectric Grease or Petroleum Jelly
- Eye Protection
- Nitrile Gloves
- Shop Rags
To remove and install the battery on your RZR Pro R, follow these steps:
1. Park the vehicle on a flat, level surface, ensure the vehicle is in PARK and remove the key.
2. Remove the driver seat by pulling up on the seat latch lever located under the front edge of the seat. Tilt the seat forward and upward to remove from the vehicle. Note: For Ultimate models, disconnect the heated/ventilated seat connector prior to removing the seat.
3. Disconnect the black (negative) battery cable first with a 10mm socket to prevent arcing and securely set away from the battery terminals. Tip: Reinstalling the fasteners into the battery posts will help prevent misplacement.
4. Pull the red boot back from the positive cable and remove the red (positive) cable with a 10mm socket and set the cable aside.
5. Remove the two screws securing the battery hold-down strap with a T40 TORX® socket and set the strap aside.
6. Push the seat lever and slide the seat forward. Pull the battery toward the driver’s side of the vehicle and tilt up to remove.
7. If reinstalling the battery, ensure it is fully charged and free of any debris to prevent damage. If needed, a new battery is part number 4014609. Follow the instructions in the Battery Charging section of your Owner’s Manual before installing the battery.
8. Clean any dirt or debris from the battery box.
9. Place the battery into the battery holder and slide into place.
10. Slide the seat all the way back.
11. Install the battery hold-down strap and torque to 53 in-lbs (6 Nm).
12. Install the positive cable first to prevent arcing, and torque to 60 in-lbs (7 Nm).
13. Install the negative cable, and torque to 60 in-lbs (7 Nm).
14. Coat both terminals with dielectric grease or petroleum jelly.
15. Reinstall the positive cable protector boot.
16. Verify the cables are secure and properly routed.
17. Reinstall the seat by sliding the seat tabs at the front edge onto the seat retainer tubes. Press down firmly at the rear of the seat to engage the rear latches. Ensure the seats are latched securely. Note: For Ultimate models, reconnect the heated/ventilated seat connector prior to installing the seat.
18. Turn the key ON to verify the battery has been connected properly. Note: When the battery is disconnected, the vehicle’s clock may need to be reset.
For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
TORX® is a registered trademark of Acument Intellectual Properties, LLC
YouTube® is a registered trademark of Google LLC
Unless noted, trademarks are the property of Polaris Industries Inc.
© 2024 Polaris Industries Inc.
