Required Tools and Supplies
- 15mm Socket
- 15mm Wrench
- Ratchet
- Torque Wrench
- Breaker Bar
- Lower A-Arm Nuts
- Lower Ball Joint Nut
- Flathead Screwdriver
- Safety Glasses
- Nitrile Gloves
- Shop Towels
For information on tools, read the Tools and Fasteners Guide. Always wear safety glasses and nitrile gloves when servicing your Polaris RZR.
To remove and install the front lower A-Arm on your RZR XP, follow these steps:
1. Park the vehicle on a flat, level surface, ensure it is in PARK and remove the key.
2. Remove the wheel from the vehicle.
- Loosen the lug nuts while the vehicle is on the ground with a 19mm socket with breaker bar, but do not remove them at this time.
- Safely elevate the vehicle. Reference your Owner’s Manual for proper lifting techniques.
- Once safely elevated, remove and retain the lug nuts and set aside.
- Remove the wheel and set aside.
3. Remove the lower ball joint fastener from the bearing carrier with a 15mm socket and 15mm wrench.
4. Lift upward on the upper A-arm and lightly tap on the bearing carrier with a soft face hammer to loosen the upper ball joint end. Tip: Pushing the hub inward helps loosen tension for removal.
5. Completely remove the ball joint end from the bearing carrier.
6. Support the carrier with a wire hanger, rope or retention strap to avoid damaging the brake line.
7. Remove the lower A-arm fasteners with a 15mm socket and 15mm wrench and discard the nuts.
8. Pivot the A-arm out from the vehicle.
9. If reusing the A-arm, thoroughly clean with a shop rag before reinstalling.
10. Inspect the ball joint and ball joint boot for wear, tears or damage and replace if necessary.
11. Inspect the A-arm bushings and pivot tubes for damage or wear and replace as necessary. When reinstalling the bushings, ensure the tapered side is facing out. Also ensure the control arm bushings are fully installed inside the arm before installing the pivot seals.
12. Reinstall the A-arm and align with the mounting holes in the frame.
13. Reinstall the previously removed fasteners from the outside and secure with new nuts.
14. Insert the lower ball joint end into the bearing carrier.
15. Reinstall the fastener from the rear of the vehicle and secure with a new nut.
16. Torque the lower A-Arm fasteners to 52 ft-lbs (70 Nm).
17. Torque the ball joint nut to 41 ft-lbs (55 Nm).
18. Install the wheel on the vehicle and tighten the lug nuts until fully seated.
19. Once installed, safely lower the vehicle until the tires begin to touch the ground. This will help keep the wheel in place when torquing.
20. Once lowered, torque the lug nuts to 120 ft-lbs (163 Nm) in a crisscross pattern.
21. Finally, lower the vehicle completely.
For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
YouTube® is a registered trademark of Google LLC
Unless noted, trademarks are the property of Polaris Industries Inc.
© 2023 Polaris Industries Inc.