Skip to content Skip to navigation Skip to footer
POLARIS OFF-ROAD VEHICLES
HELP CENTER
10/23/2023

2018-2022 RZR RS1 Battery Removal and Installation

 

Required Tools and Supplies
Shop RagsTorque Wrench
8mm and 10mm SocketsSafety Glasses
RatchetNitrile Gloves
Battery (part number 4014609)Dielectric Grease or Petroleum Jelly

    Always wear safety glasses and nitrile gloves when servicing your Polaris RZR. To remove and install the battery on your 2018-2022 RZR RS1, follow these steps:

    1. Park the vehicle on a flat, level surface.

    2. Ensure the vehicle is in park and remove the key.

    3. Remove the center hood by turning the two quarter-turn latches and pulling back from the retainers.

    4. Then lift the front storage box out of the vehicle. 

    5. Next, using an 8mm socket, remove the black negative battery cable fastener first to prevent arcing. Set the cable aside.

    6. Then slide the positive cable protector boot back and remove the red cable fastener with an 8mm socket. Set the cable aside. Reinstalling the fasteners into the posts will help prevent misplacement. 

    7. Next, remove the battery bracket fastener with a 10mm socket. Lift the bracket up and pull out to remove from the vehicle.

    8. Lift the battery out of the vehicle. The lower bracket may stick to the battery when removing. Reinstall the bracket as needed.

    9. If reinstalling the battery, ensure it is fully charged and free of any debris to prevent damage. Follow the instructions in the Battery Charging section of your Owner’s Manual before installing the battery.

    10. Next, clean the inside of the battery holder and reinstall the battery.

    11. Then reinstall the battery bracket and align the mounting hole.

    12. Install the battery bracket fastener. Torque to 8 ft-lbs (11 Nm).

    13. Next, install the positive cable FIRST to prevent arcing. Torque to 60 in-lbs (7 Nm). Then install the protector boot.

    14. Continue by installing the negative cable. Torque to 60 in-lbs (7 Nm).

    15. Next, coat the battery terminals with dielectric grease or petroleum jelly.

    16. Before proceeding, verify the cables are secure and properly routed.

    17. Turn the key on to verify the battery is properly connected. When the battery is disconnected, the vehicle’s clock may need to be reset. More information can be found in Setting the Clock on Your RZR.

    18. Next, reinstall the storage box.

    19. Finally, reinstall the center hood panel and secure the two quarter-turn latches.

    For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
    Maintenance tips, procedures and specifications can be found in your Owner's Manual.
    To find diagrams and replacement part numbers, use the online parts catalog.

    YouTube® is a registered trademark of Google LLC

    Unless noted, trademarks are the property of Polaris Industries Inc.
    © 2022 Polaris Industries Inc.