Passer au contenu de la page Passer à la navigation Passer au pied de page
MOTONEIGE POLARIS
CENTRE D'AIDE
8/25/2023

2023+ Patriot Boost INDY VR1 Spark Plug Inspection and Replacement

Required Tools and Supplies

  • Spark Plug Wrench (Included in Tool Kit)
  • 13/16-Inch Crow Foot
  • Torque Wrench
  • Safety Glasses
  • Nitrile Gloves
  • Shop Rags

For more information on tools, visit the Tools and Fasteners Guide.

Always wear safety glasses and nitrile gloves when servicing your Polaris snowmobile.

To inspect and replace the spark plugs on your Patriot Boost INDY VR1 snowmobile, follow these steps:

1. Ensure the snowmobile is on a flat, level surface.

2. Remove both side panels by turning the three quarter-turn latches. Pivot the panels away from the sled and pull out to remove.

3. Disconnect the two hood latches.

4. Lift the hood up slightly to gain access to the connector underneath.

5. Disconnect the connector and remove the hood from the sled.

6. Carefully remove both spark plug leads.

7. Clean the area around the spark plugs to prevent debris from falling into the engine.

8. Remove the spark plug wrench from the spark plug holder.

9. Loosen the spark plugs with a spark plug wrench and remove from the vehicle. If reusing, take note of the cylinders they were installed in for reinstallation.

10. Inspect the electrodes for wear and carbon buildup and verify there are no cracks around the insulation. The spark plug should have a sharp outer edge with no rounding or erosion.

11. Inspect and adjust the spark plug gap if needed. The gap should be 0.027 inches (0.7 mm).

12. If necessary, replace with the recommended spark plugs. The spark plugs are part number 3022082.

13. Install the spark plugs into the engine, and torque to 22 ft-lbs (30 Nm) with a 13/16-inch crow foot.

14. Reinstall the spark plug leads and ensure they are secure.

15. Reinstall the spark plug wrench in its holder.

16. Reinstall the hood panel, ensuring the tabs in front are properly engaged. 

17. Reconnect the connector underneath and verify it is secure.

18. Secure the two hood panel latches.

19. Reinstall both side panels by inserting the upper tab and pivoting in to engage the lower tab. 

20. Latch the three quarter-turn latches to secure each panel.

21. Finally, start the engine to ensure proper operation.

For more information, see your authorized Polaris Dealer. To find a dealer near you, use the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

NGK® is a registered trademark of NGK Spark Plug Co., Ltd.
WALKER EVANS RACING® is a registered trademark of Walker Evans Enterprises Incorporated
YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2023 Polaris Industries Inc