Passer au contenu de la page Passer à la navigation Passer au pied de page

Trail Performance Track Inspection and Tension Adjustment

Required Tools and Supplies
15mm WrenchRatchet
Breaker BarMeasurement Tool
10-Pound WeightTorque Wrench
Shop RagsSafety Glasses & Nitrile Gloves

To learn more about tools, read the Tools and Fasteners Guide.

Track tension is important to the overall performance of the snowmobile. A new track will stretch after break-in and will require adjustment. From then on, the track should be inspected before every ride to ensure the sled is reaching its full potential. Failure to do so may lead to ratcheting, hesitation and excessive wear to the rear suspension and track. 

To inspect and adjust the track tension and alignment on your Polaris snowmobile, follow these steps:

1. Before beginning, ensure the track has been warmed up. 

2. Safely elevate the vehicle. Refer to your Owner’s Manual for proper lifting techniques.

3. Rotate the track by hand to check for damage. Carefully examine the track along the entire length of each rod. Bend the track to ensure there is no breakage.

4. If inspection reveals any concerns, see your authorized Polaris Service Center.

5. Next, measure 16 inches ahead of the rear idler shaft on the track.

6. Apply 10 pounds of weight on the track and measure the slack between the track and the rails. Reference your Owner’s Manual for accurate specifications.

7. If the track requires adjustment, start by loosening the rear idler shaft bolt with a 15mm socket. Do not remove.

8. Then use a 15mm wrench to loosen the adjuster locknuts on both sides of the track.

9. Using a 15mm socket, tighten or loosen the track adjusting screws on both sides of the track to provide equal adjustment of the track tension.

10.  After adjusting, tighten the locknuts until fully seated.

11. Then torque the idler shaft fastener to specification. Refer to your Owner’s Manual for specifications.

12. Next, start the engine and apply a small amount of throttle until the track slowly turns at least five complete revolutions. Stop the engine and allow the track to come to a complete stop without applying the brakes.

13. Inspect the track alignment through the track windows in the rear to ensure the rails are evenly spaced on each side.

14. If the track is offset to either side, loosen the adjustment nuts and tighten the affected side as needed to gain alignment.

15. Start the engine again and apply a small amount of throttle until the track turns slowly for at least five revolutions. Stop the engine and allow the track to come to a complete stop without applying the brakes.

16. Reinspect the track alignment and repeat this procedure as needed. 

17. Safely lower the vehicle to the ground after confirming proper track tension and alignment.

For more information, see your authorized Polaris Dealer. To find a dealer near you, use the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Industries Inc.