Saltar al contenido Saltar a navegación Saltar al pie de página
POLARIS OFF-ROAD VEHICLES
CENTRO DE AYUDA
09/06/2024

2024+ Polaris XPEDITION Tool Holder Kit Installation

This video goes over the installation of the Rhino-Rack® Multi-Purpose Tool Holder Kit (part number 2889528).

Required Tools and Supplies

  • 5mm Allen Socket
  • Ratchet
  • Shop Rags
  • Nitrile Gloves
  • Eye Protection

For information on tools, read the Tools and Fasteners Guide. Always wear safety glasses and nitrile gloves when installing accessories on your Polaris XPEDITION.

To install the Rhino-Rack® Tool Holder Kit on your Polaris XPEDITION, follow these steps. 

1. Start by parking the vehicle on a flat, level surface, ensure it is in PARK and remove the key.

2. Open the tool holder fully and install a screw and washer into the channel nut. Repeat on the other tool holder. Note: Make sure the teeth on the washer are facing the bottom of the tool holder. 

3. Slide the tool holder into the rails and tighten with a 5mm Allen socket. Torque to 3-4 ft-lbs (4-5 Nm).

4. If installing in the bed side rail, remove the tailgate bumper and slide in from the rear. Reinstall bumper once finished.

For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

Rhino-Rack® is a registered trademark of Rhino Rack Australia Pty Limited
YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2023 Polaris Industries Inc.