Saltar al contenido Saltar a navegación Saltar al pie de página
POLARIS OFF-ROAD VEHICLES
CENTRO DE AYUDA
04/15/2024

2018+ RANGER 150 Battery Removal and Installation

 

Required Tools and Supplies
Dielectric Grease or Petroleum Jelly10mm Socket
RatchetTorque Wrench
Shop RagsSafety Glasses & Nitrile Gloves


For more information on tools, read the Tools and Fasteners Guide

Always wear safety glasses and nitrile gloves when servicing your Polaris RANGER. To remove and replace the battery on your RANGER 150, follow these steps:

1. Park the vehicle on a flat, level surface.

2. Set the parking brake and remove the key.

3. Access the battery through the left-side rear wheel well.

4. Release the battery cover strap.

5. Then remove the battery cover.

6. Using a 10mm socket, disconnect the negative battery cable first to prevent arcing and set aside.

7. Using a 10mm socket, disconnect the positive battery cable and set aside.

8. Reinstalling the fasteners onto the posts will help prevent misplacement.

9. Carefully remove the battery from the vehicle.

10. Inspect the rubber battery pad for damage or wear, and replace if necessary. The battery pad is part number 5416089.

11. If reinstalling the battery, ensure it is fully charged and free of any debris or damage. Follow the instructions in the Battery Charging section of your Owner’s Manual before installing the battery. The battery is part number 4010678.

12. Clean the battery holder thoroughly.

13. Ensure the rubber battery pad is correctly positioned in the battery holder.

14. Place the battery in the battery holder with the terminals facing backward.

15. Reinstall the positive cable first to prevent arcing. Torque to 6 ft-lbs (8 Nm).

16. Then reinstall the negative cable. Torque to 6 ft-lbs (8 Nm).

17. Apply a light film of dielectric grease or petroleum jelly to both terminals.

18. Verify the cables are secure and properly routed.

19. Clean the battery cover thoroughly and reinstall.

20. Then install the cover strap.

21. Finally, turn the key ON to verify the battery has been connected properly. When the battery is disconnected, the vehicle’s clock may need to be reset.

For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Industries Inc.