Skip to content Skip to navigation Skip to footer
POLARIS SNOWMOBILE
HELP CENTER
12/11/2023

2021 INDY XC Launch Edition Drive Chain Tension Adjustment

Required Tools and Supplies
T40 TORX® Socket15mm and 14mm Wrenches
15mm Crowfoot WrenchRatchet
Torque WrenchSafety Glasses
Nitrile GlovesShop Rags


For information on tools, read the Tools and Fasteners Guide.

Always wear safety glasses and nitrile gloves when servicing your Polaris snowmobile. To adjust the drive chain tension on your 2021 INDY XC Launch Edition, follow these steps:

1. Park the sled on a flat, level surface. 

2. Remove both side panels by turning the three quarter-turn latches. Pivot the panels away from the sled and pull out to remove.

3. Rotate the driven clutch counterclockwise to its end stop to move all chain slack to the tensioner side.

4. Lock the parking brake.

5. With a T40 TORX® socket, remove the fastener on the lower right side of the console.

6. With a pliers, remove the push rivet securing the lower right portion of the console. 

7. Remove the push rivet underneath that secures the right fender to the footrest.

8. If your snowmobile is equipped with a battery, remove the battery for additional clearance. Always remove the negative cable first to prevent arcing. The full procedure can be found in INDY XC Launch Edition Battery Removal and Installation

9. Loosen the adjuster bolt jam nut with a 15mm wrench.

10. Finger tighten the adjuster bolt until it can no longer be adjusted by hand. Then back off one-quarter of a turn.

11. Retighten the jam nut. Torque to 21 ft-lbs (28 Nm) with a 15mm crowfoot wrench while holding the adjuster bolt.

12. Reinstall the battery, if equipped, beginning with the positive cable first to prevent arcing.

13. Reinstall the push rivet underneath the console.

14. Install the push rivet on the lower right portion of the console.

15. Reinstall the lower console fastener, and torque until fully seated.

16. Reinstall both side panels by inserting the upper tab and pivoting in to engage the lower tab. 

17. Latch the three quarter-turn latches to secure each panel.

Looking for information on replacing chaincase fluid? Read INDY XC Launch Edition Chaincase Fluid Replacement.

For more information, see your authorized Polaris Dealer. To find a dealer near you, use the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

TORX® is a registered trademark of Acument Intellectual Properties, LLC
YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Industries Inc.

Keyword(s) video , maintenance , chain , tension , adjust , adjusting , tools , indy , launch ,