Passer au contenu de la page Passer à la navigation Passer au pied de page
MOTONEIGE POLARIS
CENTRE D'AIDE
07/30/2024

2018-2022 TITAN Drive Belt Deflection Inspection and Adjustment

Required Tools and Supplies

  • Shop Rags
  • Tape Measure
  • Straight Edge
  • 7/16-Inch Crowfoot Wrench
  • 1/8-Inch Allen Socket
  • 7/16-Inch Wrench
  • Ratchet
  • Torque Wrench
  • Eye Protection
  • Nitrile Gloves

To learn more about tools, read the Tools and Fasteners Guide. Always wear safety glasses and nitrile gloves when servicing your Polaris snowmobile.

To inspect and adjust the drive belt tension on your Polaris TITAN SP 155 or TITAN XC 155, follow these steps. Always measure belt deflection with both clutches at rest in their full neutral position.

1. Park the snowmobile on a flat, level surface.

2. Remove the left side panel by releasing the rubber strap and turning the two quarter-turn latches. Pull the panel out and lift up to remove.

3. Remove the clutch spreader tool and spread the panels apart as needed.

4. Turn the latch on the spare belt holder and pull out to remove. 

5. Next, place a straight edge on the belt.

6. Then apply downward pressure between the clutches to measure the deflection. The deflection should be 1¼ inches (3.2 cm).

7. If adjustment is needed, loosen the jam nut on the belt width adjuster with a 7/16-inch wrench. 

8. Then, using an 1/8-inch Allen socket, turn the set screw inward to increase the distance between the sheaves or outward to decrease the distance.

9. Once deflection has been set, hold the set screw and lightly tighten the jam nut.

10. Next, spread the clutch half an inch.

11. Using a 7/16-inch crowfoot wrench, torque the jam nut to 9 ft-lbs (11 Nm).

12. Remove the clutch spreader tool while spinning the belt clockwise.

13. Reinstall the spare belt holder and secure the latch. Reinstall the clutch spreader tool.

14. Re-check belt deflection and repeat this process as needed.

15. Next, reinstall the side panel by inserting the tabs at the bottom and top. 

16. Finally, secure the rubber strap and latch the two quarter-turn latches.

For more information, see your authorized Polaris Dealer. To find a dealer near you, use the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Industries Inc.