Passer au contenu de la page Passer à la navigation Passer au pied de page
POLARIS COMMERCIAL
CENTRE D'AIDE
11/22/2023

2024 Pro XD Full-Size Diesel Battery Removal and Installation

Required Tools and Supplies

  • 10mm Socket
  • Ratchet
  • Torque Wrench
  • Dielectric Grease or Petroleum Jelly
  • Eye Protection
  • Nitrile Gloves
  • Shop Rags

For information on tools, read the Tools and Fasteners Guide. Always wear safety glasses and nitrile gloves when servicing your Polaris vehicle.

To remove and install the battery on your Pro XD Full-Size Diesel, follow these steps:

1. Park the vehicle on a flat, level surface, ensure it is in PARK, pull the parking brake and remove the key.

2. Lift up the bench seat. 

3. Loosen the negative (black) battery cable fastener with a 10mm socket. Remove the cable and set aside. Caution: The negative battery cable must be removed first in order to prevent arcing.

4. Loosen the positive (red) battery cable fastener. Remove the cable and set aside.

5. Remove the fastener securing the battery hold-down strap with a 10mm socket.

6. Push the hold-down strap toward the rear of the vehicle to release, and lift the strap straight out of the vehicle to remove it.

7. Lift the battery straight up to remove from the vehicle.

8. If reinstalling the battery, ensure it is fully charged and free of any debris or damage. Follow the instructions in the Battery Charging section of your Owner’s Manual before installing the battery.

9. Place the fully charged battery in the battery holder. Make sure the positive terminal is toward the driver’s side of the vehicle.

10. Coat the battery terminals with dielectric grease or petroleum jelly.

11. Connect and tighten the (red) positive cable first to prevent arcing. 

12. Reinstall the positive cable protector boot. 

13. Connect and tighten the (black) negative cable. 

14. Install the hold-down strap over the battery and slide toward the front of the vehicle to secure it in the vehicle frame.

15. Install the hold-down strap fastener. 

16. Verify the battery cables are properly secured.

17. Lower the bench seat to the closed position.

18. Turn the key ON to verify the battery has been connected properly. Tip: When the battery is disconnected, the vehicle’s clock may need to be reset.

For more information, see your authorized Polaris Commercial Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2023 Polaris Industries Inc.

Mots-clés video , full , diesel , fullsize , replace , battery ,