Required Tools and Supplies
- 10mm Socket
- T40 TORX® Socket
- Ratchet
- Torque Wrench
- Dielectric Grease or Petroleum Jelly
- Eye Protection
- Nitrile Gloves
- Shop Rags
To remove and install the battery on your RZR Pro S or Pro XP, follow these steps:
1. Park the vehicle on a flat, level surface, ensure the vehicle is in PARK and remove the key.
2. Remove the driver seat by pulling up on the front seat lever and tilting the seat forward to remove.
3. Disconnect the black (negative) battery cable first with a 10mm socket to prevent arcing and securely set away from the battery terminals. Note: Reinstalling the fasteners into the battery posts will help prevent misplacement.
4. Pull the red boot back from the positive cable with a 10mm socket and remove the red (positive) cable and set aside.
5. Remove the two screws securing the battery hold-down strap with a T40 TORX® socket and set the strap aside.
6. Pull the battery toward the driver’s side of the vehicle and tilt up to remove.
7. If reinstalling the battery, ensure it is fully charged and free of any debris to prevent damage. If needed, a new battery is part number 4014609. Follow the instructions in the Battery Charging section of your Owner’s Manual before installing the battery.
8. Clean any dirt or debris from the battery box.
9. Before installing, ensure the battery is fully charged.
10. Place the battery into the battery holder and slide into place.
11. Install the battery hold-down strap and ensure the mounting holes align.
12. Install the two screws and torque to 53 in-lbs (6 Nm).
13. Install the positive cable first to prevent arcing, and torque to 60 in-lbs (7 Nm).
14. Install the negative cable, and torque to 60 in-lbs (7 Nm).
15. Coat both terminals with dielectric grease or petroleum jelly.
16. Reinstall the positive cable protector boot.
17. Verify the cables are secure and properly routed.
18. Reinstall the seat by aligning the front alignment tabs and pushing down on the rear to engage the rear latch.
19. Turn the key ON to verify the battery has been connected properly. Note: When the battery is disconnected, the vehicle’s clock may need to be reset.
For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
TORX® is a registered trademark of Acument Intellectual Properties, LLC
YouTube® is a registered trademark of Google LLC
Unless noted, trademarks are the property of Polaris Industries Inc.
© 2024 Polaris Industries Inc.
