Saltar al contenido Saltar a navegación Saltar al pie de página
POLARIS OFF-ROAD VEHICLES
CENTRO DE AYUDA
08/13/2024

2024+ Polaris XPEDITION XP and ADV Ignition Switch Removal and Installation

Required Tools and Supplies

  • 27mm Socket
  • Ratchet
  • Torque Wrench
  • Flat-Head Screwdriver
  • Safety Glasses
  • Nitrile Gloves
  • Shop Rags

For information on tools, read the Tools and Fasteners Guide. Always wear safety glasses and nitrile gloves when servicing your Polaris XPEDITION.

To remove and install the ignition switch on your Polaris XPEDITION XP or ADV follow these steps:

1. Park the vehicle on a flat, level surface, ensure the vehicle is in PARK and remove the key.

2. Hold the ignition switch from behind the console and carefully remove the switch nut with a 27mm socket.

3. Push the switch back through the hole in the console and pivot out to gain access to the connector.

4. Lift the tab on the connector and pull back to disconnect from the ignition switch. Tip: A flat-head screwdriver can be used to aid in releasing the connector tab.

5. Ensure the seal on the connector is not damaged and is fully seated.

6. Connect the connector to the ignition switch and ensure it is fully seated.

7. Align the notch above the switch with the notch in the console.

8. Reinstall the ignition switch through the console and secure with the retained nut.

9. Torque the nut to 31 in-lbs (3.5 Nm).

10. Finally, insert the key and turn the vehicle on to verify proper operation.

For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2023 Polaris Industries Inc.

Palabra (s) clave video , ignition , switch , replace , remove , install , xpedition , adv , adv 5 , xp , xp 5 ,