Saltar al contenido Saltar a navegación Saltar al pie de página

2015+ Sportsman Touring 850 and Touring XP 1000 Pre-Ride Inspection

Before you ride your Polaris Sportsman Touring 850 or Touring XP 1000, perform the pre-ride inspection as described in your Owner's Manual. Read, understand and follow all of the instructions, warnings and safety precautions in the Owner's Manual and on all product labels. Failure to follow these instructions, warnings and safety precautions could result in serious injury or death. 

During your pre-ride inspection, do the following:

1. Visually inspect the vehicle, looking for debris, leaks and worn components that may impair the vehicle’s operation.

2. Pay particular attention to the radiator area for the accumulation of debris, which can cause the engine to overheat, and clean any debris that is found.

3. Check the condition of the tires, looking for any sign of punctures or damage, and verify proper tread depth. 

4. Check the tire pressures and verify that they are to specification. Tire pressure should be 7 psi (48.3 kPa) for all tires.

5. Inspect the front and rear suspension for leaks, debris and damage.

6. Inspect the brake pads and rotors, looking for corrosion, nicks and burrs.

7. Remove the seat and inspect the intake system for blockage or debris and clean as needed. Notice: DO NOT spray water directly into the intake system, as this can result in water intrusion to the engine.

8. Next, inspect the fluid levels. Ensure the vehicle is on a level surface before inspecting fluid levels.

  • Inspect the coolant level in the overflow bottle at the right front of the vehicle. Add coolant as needed. Caution: Escaping steam can cause burns. Never remove the pressure cap while the engine is warm or hot. Always allow the engine to cool before removing the pressure cap.
  • Inspect the front brake reservoir on the handlebar for proper fluid level. Also inspect the rear brake reservoir underneath the storage compartment trim. Add fluid as needed. Tip: Use a flashlight to illuminate the brake fluid reservoir.
    • This can be accessed by removing the two fasteners in the front of the trim and pulling back.
  • Remove the oil dipstick and wipe with a clean shop towel. Reinstall the oil dipstick fully and remove to inspect the oil level. Caution: Operating with insufficient, deteriorated or contaminated engine oil will cause accelerated wear and may result in engine or transmission seizure, which could result in loss of control and serious injury or death.
  • Add oil as needed. Caution: Do not overfill. Overfilling can result in loss of engine performance and an oil-saturated air filter. Use a suction device to remove excess oil if overfilled.

9. Turn the key on and inspect the headlights, taillights and brake lights for proper operation.

10. Sit on the vehicle and check the steering for smooth operation from full left to full right.

11. Verify proper brake lever and pedal movement, taking note of any binding or sticking.

12. Operate the throttle lever and ensure it does not stick or bind.

13. Start the engine and verify the low oil pressure light is not illuminated.

14. Stop the engine with the engine stop/run switch and ensure the engine does not restart.

For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Inc.

Palabra (s) clave video , pre-ride , inspect , check , maintenance ,