Skip to content Skip to navigation Skip to footer
POLARIS SNOWMOBILE
HELP CENTER
2/12/2024

2022+ 650/850 PRO RMK Matryx and Matryx Slash Spark Plug Inspection and Replacement

Required Tools and Supplies

  • Spark Plug Wrench
  • 13/16-Inch Socket
  • Torque Wrench
  • Safety Glasses
  • Nitrile Gloves
  • Shop Rags

To learn more about tools, read the Tools and Fasteners Guide

Always wear safety glasses and nitrile gloves when servicing your Polaris snowmobile. To inspect and replace the spark plugs on your model year 2022 and newer 650 or 850 PRO RMK Matryx or Matryx Slash, follow these steps:

1. Ensure the snowmobile is on a flat, level surface and remove the key.

2. Begin by removing both side panels by turning the three quarter-turn latches. Pivot the panels away from the sled and pull out to remove.

3. Disconnect the two hood latches and disconnect the connector to the 7S display.

4. Pivot the hood forward and remove from the sled.

5. Carefully remove both spark plug leads. 

6. Clean the area around the spark plug to prevent debris from falling into the engine.

7. Remove the spark plug wrench from the spark plug holder.

8. Steer the skis left or right to gain better access to the spark plugs.

9. Loosen the two spark plugs with the spark plug wrench and remove from the vehicle. If reusing, take note of the cylinders they were installed in for reinstallation.

10. Inspect the electrodes for wear and carbon buildup and verify there are no cracks around the insulation. The spark plug should have a sharp outer edge with no rounding or erosion.

11. Inspect and adjust the spark plug gap if needed. It should be 0.027 inches (0.7 mm).

12. If necessary, replace with the recommended spark plug. Spark plugs are part number 3022082.

13. Install the spark plugs into the engine and torque to 22 ft-lbs (30 Nm) with a 13/16-inch socket.

14. Reinstall the spark plug leads and ensure they are secure.

15. Reinstall the spark plug wrench in its holder.

16. Reinstall the hood panel, ensuring the tabs in front are properly engaged. 

17. Reconnect the connector underneath and verify it is secure.

18. Continue by securing the two hood panel latches.

19. Reinstall both side panels by inserting the upper tab and pivoting in to engage the lower tab. 

20. Latch the three quarter-turn latches to secure each panel.

21. Finally, start the engine to ensure proper operation.

For more information, see your authorized Polaris Dealer. To find a dealer near you, use the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC
WALKER EVANS RACING® is a registered trademark of Walker Evans Enterprises Incorporated 
NGK® is a registered trademark of NGK Spark Plug Co., Ltd. 

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2024 Polaris Industries Inc