Skip to content Skip to navigation Skip to footer

FOX® Rear Suspension Kit Installation

The following video demonstrates how to install a FOX® Rear Suspension Kit (part number 2881412) onto your Polaris snowmobile. The video includes removing the seat (0:40), elevating the fuel tank (1:07), installing mounts (1:37), removing the shock assembly (2:49), installing the new FOX® air shock (3:40), installing the air fill assembly (4:51), installing the setting decal (5:44), reassembling the fuel tank and seat (6:20), removing the rear track shock (7:25), comparing spacers on the old and new shocks (9:27), installing the new rear track shock (10:00) and how to make adjustments (12:29).

To install the kit, you need a 3/16-inch drill bit, drill, rivet gun, Phillips screwdriver, TORX® screwdriver set, 15mm socket and 15mm wrench.

View the instructions for this kit by searching the Polaris Accessory Installation Instruction Site. View the Accessories page to view the full selection of shocks available for your snowmobile.

More information on suspension adjustment can be found in your Owner's Manual.
To find a Polaris Dealer near you, use the Dealer Locator.

FOX® is a registered trademark of Fox Factory Inc.
TORX® is a registered trademark of Acument Intellectual Properties, LLC. 
YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Industries Inc.

Keyword(s) shocks , shock , video , install , installing , installation , fox ,