Skip to content Skip to navigation Skip to footer
POLARIS OFF-ROAD VEHICLES
HELP CENTER
1/4/2024

2024 Polaris XPEDITION Rail D-Ring Kit Installation

This video goes over the installation of the Lock & Ride MAX D-Rings (part number 2890894).

Required Tools and Supplies

  • Phillips Screwdriver
  • Eye Protection
  • Nitrile Gloves
  • Shop Rags

For information on tools, read the Tools and Fasteners Guide. Always wear safety glasses and nitrile gloves when installing accessories on your Polaris XPEDITION.

To install the Rail D-Ring Kit on your Polaris XPEDITION, follow these steps. 

1. Start by parking the vehicle on a flat, level surface, ensure it is in PARK and remove the key.

2. Loosely assemble the clamp, wing screw and T-nut.

3. Insert the T-nut through one of the port openings in the rail. Slide the clamp assembly to the desired location on the rail and tighten wings screw until fully clamped. Tip: A screwdriver can be inserted through the top keyway on the wing screw to tighten the clamp.

Loop of the D-ring must point in the direction of the load. Use minimum of two D-rings for each 50lbs of cargo. Do not exceed strap manufacturer’s recommended load. Do not use tools to tighten ratchet strap. Attach only one hook to each D-ring. 

View the instructions for this kit by searching the Polaris Accessory Installation Instruction Site.
For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2023 Polaris Industries Inc.